Easily add an additional protected circuit with these 12V piggy back holders suitable for Mini or Standard blade fuses. These fuse holders turn 1 slot into 2 which allows individual protection to each circuit. The holders are perfect for installing dash cams straight into your car fuse box for a discreet installation without cutting, splicing or soldering.
We now include a free 3amp fuse (either Mini or Standard depending on which version you order) which should be compatible with most dash cams. However, you should check the fuse is correct before installing.
Wire length: 12cm
Fuse slots: 2
If you’re not sure which fuse you require, please see the photo to the left which shows the different type of fuse.
Installation is easy and hassle free:
1. Simply remove an existing fuse from the fuse box, insert that fuse in to the bottom slot of the fuse tap.
2. Insert a suitable fuse for the new accessory in to the top slot.
3. Crimp your new live wire to the blue butt terminal on the fuse tap.
4. Insert the fuse tap into the fuse box slot where the fuse originally was.
Important – hardwiring a camera is done at your own risk and we cannot be held responsible for any installation costs or additional costs that may be incurred after a fault or failure of camera, mount, hardwire kit, or car electrics. We recommend that all components are tested thoroughly before installation. We strongly recommend that you hire a fully qualified, insured, and experienced auto-electrician to install the hardwire kit for you. Before continuing, please make sure you have read our terms and conditions (see point 25) relating to hardwiring cameras.
